The ends of the fairing tunnels are rounded and tapered. The silhouette of the tunnel end isn't perfectly round, but more like the ...

The instructions say to make the half-round tunnels from balsa. It's easier to form, sand and seal these if made from hardwood dowels...

1/8" of the paper tip is cut off with a razor blade. Because the holes I drilled are probably deeper than needed, I cut the nozzle...

The Vernier nozzles are small! Small cones are made from 1" square pieces of copy paper. I pre-rolled the squares with a small ...

This is all four with the small ends facing you. I've looked at a few pictures of the real vernier shrouds. It's hard to see th...

  The sides are slightly tapered to the center. Mark and sand with 220 grit on a block. The small end is hard to see wh...

To start the notch, my 2' machine square was set down the length of the stick. This gave me an accurate 90 degree to rest my razor ...