On the left is the nose cone tip decal. It is an arc to fit the nose cone tip taper. On the right side was my first attempt. I painted the s...

If you want to mask the gluing line for the root edge of the K pieces - The ANTAR templates for the masking and decal placement are availabl...

Notice the pencil mark on the tube edge. I like to continue the fin alignment lines over the edge when the fin is even with the tube and cov...

Whoa, that's a lot of balsa! I was building four kits. This is right after shooting the CWF filled balsa with Duplicolor Filler/Primer. ...

The two clay squares were weighed and came in at little over 1/2 oz. You'll have to widen the hole in the base of the nose cone shoulder...

Before gluing the long "I" and one of the "H" pieces together -  I like to sand the leading edge of the I piece round. I...

The launch lug is cut in two for two 1" long sections. These lugs were made of stiff material and didn't crush when cut with a new ...