Here's the display support. I didn't have all the dowels that should have been in the kit bag so I used a piece of Bamboo skewer. It...

The next large fins are glued at a 45 degree angle to the previous glued fins.  Do your best to center them and check back a few times befor...

The launch lug is glued on the bottom center pencil line. The two thin cover plates are glued on, tucked into the root edge of the launch lu...

The top and bottom front plates are creased to fit and cover the open area at the tp of the rear assembly. The embossed lines were folded ov...

There's the two internal vent tubes with the BT-50 main tubes glued to the outside. So the ejection charge goes up - turns left - then t...

There was a molding divot near the base of both nose cones. Apply a small CA glue drop and let thoroughly dry. While drying, prop the nose c...

The canopy is made up of three pieces. The two sides and the many folded top. Do a few dry fits (no glue) to be sure you are lining up the t...