From Step 9B Subsection A - Amendment WB1074: The S-1 bottom plate is cut out and fitted. I cut out the "Engine Cut-Out" hole and ...

To mask the fins, set them in place on the lower tube with the extended fin tip on the fairing. Using the color separation lines printed on ...

Earlier I mentioned that I cut the new fairings a little wide. The widest part of the bottom overhung the body tube by a slight bit. After a...

Before any glue was used, I slightly rounded the fairing by pressing it into the heel of my hand with a dowel. Glue was applied to the back ...

Here's a tank fairing cut from the pattern sheet in the kit. While these are certainly usable as is, I wanted to get a better fit and a ...

After the glue has dried on the start of the Popielium band you can begin wrapping the line. Using a toothpick, white glue is applied down t...

After trimming off the overhang, I did have to sand the bottom of the nozzle bands flat and smooth. To make a smoother edge of the nozzle, I...