Recently I made extra fins for a second Quest Cobalt model. The kit has almost 1/8" thick fins. I only had 1/16" balsa on hand....

Before using the tape strip, pre-roll the aeroshroud stock into a smooth cone. This is a big shroud so take it slow or creases could fo...

The two wing pieces are glued together. As the instructions showed, check to be sure the root edges are lined up with a straightedge. Sa...

The canopy was molded with a much sharper edge. Trace a pencil line around the edge for a cut line. Cut just outside the line. Th...

I cut the nose cone base off a little wide. There wasn't a definate edge and I didn't want to cut it too short. The plastic wa...

I found this white sticker over the original hang topper on the Quest Raptor kit. The age recommendation went up from 10 to 14 years. ...

The curved front of the inlet fins were sanded with some 220 grit wrapped around an old engine casing. I cut off the uneven front tip...