I'll be camping with Dakota the Blue Merle Sheltie from Tuesday through Thursday. I won't have internet! Posts will resume on Friday...

Start the cone form by rolling the fairing in the heel of your hand. Roll the dowel in an arc putting a slight curve into the cardstock. Yo...

The instructions say to form the fin fairings by rolling them around a sharpened pencil. I sharpened a larger 5/8" dowel. I would think...

The back side of the WD-2 dowels need to be sanded flat to glue onto the body tube. This can be difficult, the dowel will want to roll. Mark...

The fin pattern is taped down, face up on the cutting board. The clear fin material is taped on top. Using a straightedge and sharp knife - ...

The crescent shaped piece is the shroud former pattern. Set the inside edge on the card the 20/60 rings came from. Trace with pencil. Cut wi...

I used a new blade and my aluminum angle to cut the fin slots. The masking tape wraps made it easier to see the start and stop points. After...