The flat outside face of this 20/50 nozzle support ring will visible on the finished model, even with the end of the BT-50 Orbiter body. San...

The top edge of the fins will glue to the sides of the motor mount tube. The die-cut edge isn't perfectly flat. I flattened the root edg...

Here's how we used to do it - Gluing the engine block in the old Wac Corporal kit. I like how the instructions tell you: "Put a ...

Test the fit of the nozzle and coupler in the body tubes. TIP: I usually sand an angle on the lip for easier insertion. With this small ...

There are two small "dots" glued onto the body tube forward of the dowels. These are cut from thick card stock. They won'...

Regular brown masking tape is used between the fins making sure to cover any open areas on the body tube. The rest of the body tube w...

The new, wider fairing was glued onto the split engine tube. CA glue was applied with a Q-tip. After drying the fairing was lightly sa...

I bought some of the self adhesive 400 grit sandpaper from the Klingspor website. You could spray some adhesive on the the back of some ...

Sometimes repairs sit for a year while I figure out a good way to fix them. After making trim spray paint decals for the latest MR Little J...