Custom Nomad Build Part 14 Sticker Trim

Instead of cutting down the dotted lines, I cut off the dotted lines between the panels.






Set the panel edge into the body tube / root edge then over the rest of the fin.

These are hard to get lined up. It might take a few tries, don't press down until you are sure it's strait down the leading and trailing edges.





The black lugs should friction fit between the two BT-60 assemblies.
Sight down the body tube to be sure they are in line with the fins.

After they are straight, they can be glued in place with CA.




After all the handling during construction, some of the white paint had small chips on the assembly edges.

I sprayed some gloss white onto waxed paper. A Q-tip was dipped in the paint and used like a brush to cover the edges.