Semroc Defender Build Part 21 Assembly

The long strips were slipped underneath the upper body tube section and between the black tubes.

The upper end of the strip goes 1/8" under the upper tube.
Look underneath the lug and you can see the pencil mark at 1/8".


Glue was applied under the lower end of the strip.

Before it set up, the fin can was slipped over just the end of the three tubes.
Here I could check the alignment of the strip end and white fin.
Any adjustments were made before the glue could set up.

A piece of masking tape held the strip in line with the fin.