Mars Snooper Build Part 30 Upper Mask

This is one of the three sides with the Scotch tape in place.
The black marked side is facing in. The cut "tapered arrow" point is on the inside.
It takes some time to get the strips straight. Sight from the rear to be sure the tape goes in a straight line.



The remaining open area in the center gets a long triangle of masking tape.
To keep any over spray out of the tube, an engine casing on a dowel goes in the rear. A rolled piece of paper slides in the top.




I went to Home Depot with an old Estes catalog in hand to match the blue on the Mars Snooper catalog picture.
After all the masking was removed, here's the result.
The point of the triangle is centered. The angle of the picture makes it look a little off.