I did sand down the tube even with the shorter engine blocks.
This won't effect the fit or finish of any upcoming parts.
The pencil lines were extended over the top of the three engine mount tubes.
Apply a line of glue on a pencil line and assemble the engine mount tubes.
Bear in mind the position of the engine hooks. If you marked them correctly it shouldn't be any problem.
The three tube engine mount was slid into the longer BT-60 tube for drying.
This might help keep the engine mount "round".
There is no glue on the outside of the three tubes! This is just for the drying of the inside glue lines of the motor mount tubes.
No comments:
Post a Comment