Even though the instructions have you make the two engine mounts separately, I built them at the same time.
Step 9 doesn't mention cutting a notch in the RAH-5055S for clearance over the engine hook.
The picture shows the gap above the hook without the notch in the ring.
I went ahead and cut a notch in the ring.
The fit of the forward ring was perfect.
The fit of the pre-notched rear ring was a little loose.
To build up the inside diameter, a ring of white glue was ran around the inside edge.
After drying, this was all it took to get a good friction fit.
No comments:
Post a Comment