AVI Nike Tomahawk Build Part 14 Internal Adapter Tubes

Two wraps of 110 lb. cardstock gave a good fit of the BT-19 into the 20 mm tube.

Here I'm spreading out the white glue with the back side of a razor blade. Any flat card could be used.
Over the years I've learned it takes very little glue to adhere cardstock whether it's a should or a build up wrap.

The two complete wraps are on and the ends almost meet.

A peeled engine casing was slid in the BT-19 tube for support when I rolled a clean dowel over the wraps.

This is all the parts dry fit before sliding and butting together the joints.

From the bottom up -
20mm tube slid into the Adapter centering rings.
The BT-19 tube with two wraps of cardstock slid into the Tomahawk plastic fin can.
Out the top is the yellow coupler to join up the long 20mm Tomahawk tube.