AVI Nike Tomahawk Build Part 9 Lower Adapter

This is how the adapter dry fits together.

The two center (ring) pieces are the thick mat board.

The two mat board squares were glued together with white glue.
Plenty of clothespins held them together when drying.

Notice the rings are on the 20mm tube. This helps keep them in line and perpendicular to the tube center line.

The low end of the adapter needed an interior support ring.
The shroud is already over the 35mm coupler.
The inside ring was pressed in place and a glue fillet applied.

This is the lower half of the adapter assembly slid into the 35mm tube.