The belly air scoop pieces are cut from the printed sheets.
Use a razor blade and straightedge for the straight edges and sharp scissors for the curves.
I felt the belly scoop stock was a little thin so I laminated some 110 lb. card stock to the underside. It's much stronger now.
Just like any other shroud, pre-curl the card stock by pressing a dowel over the shroud in the heel of your hand.
The fins were glued on earlier using the Aileen's Super thick Tacky Glue.The root edges needed a slight angle sanded in them for a better fit against the curved body shroud.
Glue the right side of the air scoop on first. It is slightly wider than the left side and allows for a glue overlap tab..
No comments:
Post a Comment