Estes Gyroc Build Part 1, Parts

Here's a build by request, the Estes Gyroc, # K-24
I received my first Gyroc as a Free Kit for placing a $5.00 Estes order.

Wayne Hill's Rocketry Blog gave some history:
http://rocketry.wordpress.com/2006/06/06/rocket-of-the-week-662006/
"The Gyroc was originally released in 1965 and was offered as “Free with a $5.00 order” in the 1967 Estes MRN. The kit was listed as K-24 and was offered through 1983."

Years ago my first launch experience with the Gyroc wasn't successful.
The moment it left the launcher the fin panels flipped. I didn't install the hold-down tabs correctly. The Gyroc did a tight loop and stuck itself into the dirt. I'm hoping for better luck this time.

On the upper left you see how it appeared in the 1969 Estes Catalog.
As far as I know, this was one of the first helicopter kits available.
I won't be attempting this paint job. It would be tough to get the spiral paint patter under the large wing fin.
In later catalogs the Gyroc was painted yellow overall and used some of the black decals from the Beta kit.

The parts from left to right:
The "Tape Hinge" material will be cut from the border pieces left from a stick on CD label.
The "Flap Holders" will be carved from a larger craft stick.
An LL-2A launch lug, 1 1/4" long
BT-20D body tube, 6 1/2" long
BNC-20B nose cone
EB-20B engine block
1/16" thick balsa sheet (once known as BFS-20)
Instructions printed from the JimZ website
http://www.spacemodeling.org/JimZ/estes/k-24.pdf
Elastic thread not shown