Tape the two halves of the wing together. Line up the root edges on a straightedge.
The two wings flip in opposite directions, but tape both wings facing the same way.
When the wings are set on opposite sides of the body tube they will flip correctly.
Before setting down the sticky hinges, wipe down the hinge area.
You don't want any sanding dust, the tape won't stick very well to sawdust.
The center of the hinge strip was marked with pencil. These marks will go right over the joint.
Don't set the hinge down with your fingers. Any oil or dust will diminish the stickiness of the hinge.
Burnish the hinge with the end of a Q-tip.
The Q-tip won't scar or dent the balsa.
Remove the masking tape from the other side of the hinge.
Make sure the two flat edges are even then fold it over and make a sharp crease.
No comments:
Post a Comment