Before the shroud glue dries slide the lug in place and make sure it lays straight.
Remove the lug.
A small amount of glue was slid under the sides of the open slot where it touches the body tube.
Very little glue is needed.
With a clean dowel roll roll the corners of the open slot down onto the tube.
The inside shroud ring joint got a glue fillet.
It's too tight to get the glue nozzle or a finger in the small area.
Glue was applied drop by drop on the end of a rounded dowel.
Excess glue was picked up with a Q-tip.
No comments:
Post a Comment