TLP Pershing #K046 Build, Part 40, Paint!

A light shot of white shows some lines running down the Titebond M&TG fillets.
The inset picture is after some light sanding with 400 grit wrapped around a Q-tip for cushioned sanding. Light sanding takes down the ridges. The paint that is left even helps fill the slight furrows.

You can be as careful as you can when smoothing out the Titebond M&TG fillets, but there will be lines at the sides and glue boogers at the ends.

I thought I might get by with some Rusto 2X Hunter Green. The TLP instructions say olive drab or dark green should be used. This Hunter Green isn't close to olive drab.

This will be a big model to spray. I may have to pay the extra for two cans of the Testor's Master Modeler paint.

Before anybody comments about using a gloss paint - I know.
I spray gloss colors for better decal adhesion and transfers. You can always hit the model with a dull coat over the glossy decals and paint.