There are six round circle decals going around the top of the nose cone. Spacing and aligning these took some extra time.
A paper strip was wrapped around the cone tip and the overlap marked.
This length was divided into six sections.
These marks were transferred onto some masking tape.
The marked tape strip was wrapped around the cone.
The bottom edge of the tape will be the top of the circle decals.
The circle decals were cut apart and set onto the nose cone below the pencil marks.
There is a very thin line running around the nose cone.I cut it from an extra black decal block.
Normally a decal that goes horizontally around the nose cone would be curved. This one is thin enough it can conform fairly easily.
No comments:
Post a Comment