All the centering rings and two wings are carefully laid out on the foam board. You do have to follow the instructions sheet to get all the parts on the sheet.
Be sure and use a new sharp knife when cutting out the rings.
On the left is how the ring looks right off the sheet.
On the right is the ring after sanding the edges smooth. I tend to cut out things like this slightly oversize and sand to the best fit.
I was in California when I started this kit. I had to buy some supplies out there.
Here's a small sanding block I found at Ace Hardware. The block is soft rubber. The sanding strips have a Velcro like backing and stick to the flat side of the block.
No comments:
Post a Comment