Micro-Maxx Model Storage, Part 1

At one time I built and launched quite a few Micro-Maxx models. The finished models were storeded in different places. I wanted them together, protected in one location.

A cardboard box will give them good side wall protection, but how to keep them from sliding around?

I found a thick piece of cardboard and it was cut to fit the bottom of a box.


That thick bottom piece was set down and the models placed on the board, more or less evenly spaced.
The shorter models can stand, the longer models will lay on their side.

Sharpie "dots" marked the locations of small dowels that will slide into the engine mounts. I tried to line up the dots in a straight line.