A positioning template is cut from the instruction sheet.
When set in place I traced a pencil line a little inside the template edges.
The paint was carefully scraped away staying inside the pencil lines. It is important that the plastic pieces cover these scraped areas.
I marked the inside edge of the piece to show where the Beacon Fabri-Tac glue should be applied - on the inside edge. You can't use a wide bead of glue, it might squeeze out the side and mar the finish.
This worked out better than I hoped.
All four detail pieces are very well adhered with no glue showing outside the edges.
The gloss silver is a good contrast over the flat gray body.
You can't beat that Fabri-Tac.
ReplyDelete