Centuri Quasar Clone Build, Kit #KC-7, Part 7, Gluing Up The Ramjets

The plywood stop disk (from my Odd'l Birdie and Sputnik kits) was glued to the top of the BT-5 sized coupler.

The hardwood Ramjet cone is glued on top of that.

The Bic pen segment nozzle is glued onto the narrow tapered end of the nose cone segment.

A "fillet" of CA glue was applied around the joint using a toothpick.

Both the front end Ramjet and the rear end 

Nozzle are recessed 1/16" down inside the BT-5 tube.

All three are ready to go - 

To be glued onto the outside edge of the three fins.