Enerjet by Aerotech, Astrobee D Build, Part 19, Fin Tip Lift Fix

Like the leading edge sticker lift,

The rolled over tip of the strip was starting to lift.

This would show as a swelling on the finished model.

A drop of medium CA was set on scrap cardboard.

I dipped the tip of an old X-Acto blade into the CA.

The glue was dragged down into the open gap.

The gap was pinched between my thumb and forefinger while covered with a paper towel.

Pull up as you squeeze the sides together so the paper towel absorbs any glue that is worked out.

Here's the formed tip with the sticker swelling glued down.

This had to be done on all four fins.