Enerjet by Aerotech, Arreauxbee-Hi, Finished

Here's the finished model.

The 30" rip-stop nylon parachute is attached to the long 1/4" wide elastic shock cord, 12" down from the upper body section.

The aluminum motor retainer is adhered to the end of the motor tube using 15 minute epoxy.

The low end with the six AT-022 fin stickers.

The fun part was getting all the pieced runway/tunnel pieces to line up.

The upper body payload section with the Aerotech General and Arreauxbee-Hi decals. Pieces of masking tape were set down as outside edge guides before centering and placing the two stickers.

The long nose cone and upper body painted silver.