I wanted some of the epoxy to be on the inside of the body tube, directly around the screw - sort of an interior fillet.
A toothpick was dipped into the epoxy and set into the drilled hole. With an in and out motion, a ring of epoxy was left on the inside and outside.
Slide the rail button onto the screw.
Dip the tip of the screw in the left over epoxy.
Screw the rail button into place. Tighten until the back of the button is flat against the body tube.
Don't overtighten, you don't want to strip what threads you are making in the body tube.
In the above picture,
Notice the squeeze out of the epoxy.
Wipe off the excess. Depending on the drying time of your epoxy, it might run! I use 30 minute epoxy and a drip could form.
No comments:
Post a Comment