Centuri Skylab Build, #KB-4, Part 7, Fitting The "Super" Shroud

Mentioned in the previous post - 

Here's the smaller end showing the inside stepped shrouds.

This gives a better fit and adhesion area onto the smaller tube.

One of the previously made centering rings is glued into the doubled shroud. 

After the glue dries, the edge should be stiff enough to sand off, even with the face of the centering ring. 

The fit is good -

Even if the low end were a hair wider than the larger tube, the 3nd printed instrument wrap would cover any shroud lip.

In the next post:

Now that all the parts are almost ready, the actual build can start.