Wood glue fillets can be sanded, just be careful not to sand into the wood.
It doesn't look good now, but a few more white sprayings should cover things up.
Some of the tunnel joints were close, these were open, but no more open than the body tube/adapter joint.
I probably could fill these joints, but won't this time around.
Looking ahead -
The heat shield will be painted black, masked off using Scotch tape cut in an arc.
Paint the vernier covers red?
That would be difficult, they are only slightly raised.
I could use a decal sheet for four small red dots, or -
Punch some red vinyl using my rotary punch. This red vinyl is left over from the Skylab build.
No comments:
Post a Comment