Estes Sandpiper, Kit #1389, Part 11, Screw Eye & Nose Cone Pattern

I picked the nose cone shoulder with the screw eye attachment.

The hole did need enlargement using a small file.

Before I can release the decals and templates, I have to print and test the size and fit.

I printed and cut out the nose cone decor pattern over the nose cone and winglets. The black paint line is at the bottom edge of the pattern. 

The one I drew up was a little too long. The lower edge should be just above the halfway point of the finlets root edge.

I made adjustments to the template page.

Here's the templates, as close as I could get them.

These and the decals will be available to Patreon subscribers after I place the decals on the painted model.