Estes Aries SST, #1927, Build, Part 8, Engine Mount & Re-gluing A Wing

The Kevlar, elastic and heat shrink wrap are pushed down and through the engine mount for gluing into the main body tube.

With the Kevlar line, shock cord and heat shrink tube out the back of the engine mount - 

To get the lines out the top, I made a hook out of a coat hanger. Slide it into the top, hook the wire on the shock cord and pull through the front of the tube.

 

After the glue set up on the wings I double checked the alignment. It was off, enough that one wing was cut off and repositioned.

Be sure to cut into the glue, not into the tube when removing a fin.

The engine ribs are glued 3/8" from the root edge.

I cut a strip of tape, 3/8" wide to use as an alignment line.

The picture shows a dry fit, no glue yet.

Note the rear of the rib, it overhangs the rounded trailing edge. The back end of the rib was sanded back, just to the start of the rounded edge.