Pages

▼

Saturday, November 14, 2026

My Work Area - Money Saving TIPS


I don't have a dedicated build area, just the kitchen table. I'm single, so I can get away with this.
I prefer building low power so my work area can be smaller.

Before starting a new build, everything gets cleaned up and organized.
A new #11 style blade goes in my X-Acto handle. For cheap #11 style blades: CLICK HERE 
The old break-off knife tip is snapped off.

The break-off blade knife is for freeing up laser cut fins and general cutting.
The X-Acto knife is for fine shaping and cutting.


Both sanding blocks get new sandpaper. 
Estes and Du-Bro sell great aluminum blocks: CLICK HERE
One block gets 220 grit, the other gets 400 grit.

I buy self-adhesive sandpaper on a roll. It's way cheaper than purchasing the sandpaper cut to size: CLICK HERE

7 comments:

  1. I have one of the older extruded aluminium "tee"-section sanding block from long ago (not bad back when they were released), but the narrow grip isn't as comfortable over time as the wider grip you've got on the more recent Estes and Du-Bro sanding blocks.

    ReplyDelete
    Replies
    1. Hi Naoto,
      The Estes and Du-bro style blocks are much more comfortable than the tee blocks. I have a tee block but haven't used it for years.

      Delete
    2. I do have the one from Great Planes (ordered it though a local hobby shop). which has the more comfortable grip. The only downside is that I ended up with the longer one -- which would be great for the larger built-up R/C planes (which I don't build). Was my fault for not telling the hobby shop that I wanted the shorter one, which would be more suited for what I tend to build (low-powered model rockets and smaller rubber-band powered model aeroplanes).

      Delete
    3. Before I got a sanding block, I used to use a literal block of wood (about 1" x 2" x 4") to which I would wrap with piece of sandpaper and secure with thumbtacks.

      Delete
  2. I use the same sanding blocks and paper but I put a layer of blue painters tape between the aluminum and self-adhesive sandpaper for an easier change.

    ReplyDelete
    Replies
    1. Thanks Chris -
      I'll have to try that! Sometimes when pulling off the sandpaper, little bits of adhesive are left on the block.

      Delete
    2. Those little bits of sandpaper are why I started using the painters tape. Less of a hassle than pulling out the heat gun or goo gone…

      Delete