The Tomahawk marking guide ends matched up when wrapped around the tube. I marked the fin locations. TIP: Always check the guide by rotatin...

It's easier to use tweezers to grab the end of the shock cord. Pull the cord through the slit until 1/4" sticks outside the body tu...

The shock cord install reminds me of the oldest kits. You made two slits in the body tube and laced the shock cord through them. You were le...

In the instructions, both of the two models have a slit cut in the upper body tube. The shock cord is fed through the slit. The exposed shoc...

Always round over the corner ends of couplers for a smoother slide in the tubes. This coupler is marked 3/8" from the ends with a cente...

One of the lugs was missing from the opened kit.  On the left is the original, yellowed with age lug. The longer lug is for the Tomahawk. On...

All the outside edges (not the root edge) get a narrow bead of glue. Smooth and even the bead with the side of a finger. After the glue drie...

The die-cut hold down "tics" have to be cut through and extended to finish off the tip of the leading edges.   Start the blade cut...

I always found this combo "Pak" kit interesting. The eight finned Exocet and I.Q.S.Y. Tomahawk. Produced from 1986 - 1989. BT-5 ba...

This is one of those kits that comes alive when the decals are applied. A winning visual combination - Big graphics in three colors. The top...

The upper wing decals -  Set the black rectangles down first. The red/black stripes should fit close but not over the leading and trailing e...

I got the launch lug placement wrong!  I'm usually on top of these things, but for whatever reason the launch lug was glued on the top w...

Assembly is complete except for the parachute and shock cord ties. Time for paint! Note the dowel/engine casing painting wand locked in the ...

I no longer waste time with glue fillets on the sides of launch lugs. That glue line was straightened and the width narrowed by pinching you...

Stack the rudder assemblies to be sure the glued angles are consistent. If they don't line up, apply a little warmth with the low settin...

The root edges of the rudder fins have to be sanded at an angle. Mark the flat root edges shading with the side of a soft pencil. The pictur...