On the left is the mid section mask after the gloss black is sprayed. The tape was set down the middle of the wide Sharpie ink outlines. I u...

The Ultra Fine Point Sharpie end nibs appear to dry out quickly. Keep a piece of paper handy to get the ink flowing again. The picture shows...

The main upper body was spray painted gloss white. Three coats of paint, lightly sanding between coats 1 and 2.     Masking over corrugation...

Jumping around again: The centering ring with the small hole in it is glued even with the bottom of the core body tube. That small hole desi...

There are recesses molded into the top and bottom of the long tunnel. Set the tunnel into the flat areas on the top and middle wrap and chec...

The Antennas have raised vertical yellow bars. I wasn't sure about masking these, they would be a bear to hand paint. I figured I'd ...

The wire anchor slot needed a shot of filler/primer and smooth sanding. This tube had already been filled with CWF and shot with filler/prim...