Where you can, cut the decals close to the ink like on the "B" Aerojet General and "C" S/G stickers.  The sticker thickn...

Note: These are not water slide decals but peel and stick.  I rub some water onto the body tube while the sticker sits on my knife edge in a...

There is a choice of the "Flight" version with screw heads around the upper section or The "Launch" version has the self...

With the TTW tabs locked into the fin lock rings, the body tube is squeezed in on four sides. The rear centering ring is slid over the engin...

The fins are glued into the body tube slots and fin lock tabs. Apply medium CA down the foot edges and onto the edge of the tab rood edge th...

The pre-cut fin slots are removed before the engine mount. TIP: Don't attempt to push the slot pieces inside the tube. They'll get ...

Here's the directions to glue in the tube coupler. While the model is constructed using medium CA glue -  I'd recommend using epoxy ...