The short tubes have interior seams! You'll be able to see them on the finished model so of course, I'm filling them!
The launch lug ends were a bit rough, sand them smooth with 400 grit.
The heavy card stock pieces are laser cut.
These will need some cleaning up.
Sand the burnt edges flat on a block.
Look at the right side picture - the side wasn't cut flat. I sanded it down and evened up the line.
The notches in the wing fin fit over centering rings.
TIP: The edge of the card stock piece were pressed into the wing fin notches to square them up and make for a better fit.
No comments:
Post a Comment