Estes Gauchito Build #1279 OOP, Part 2, Finger Tab Removal

I like my models to stand up straight on it's fin tips! Do you really need that finger tab?

"Score" the break point with wire cutters. Don't expect to cut through the engine hook with the wire cutters alone.

Look close at the inset picture - you can see the lightly scored line.

I use two sets of pliers to break off the finger tab.

Bend the tab back and forth. It should take three or four bends to break off the tab.


Flip over the engine hook with the sharp 90 degree end to the back of the model. The rough break/cut goes to the top of the mount, under the engine block.