Quest Falcon #Q1009 Build, Part 10, Name Sticker

Under the Falcon beak is another sharp inside cut.

I would do the same as on the rear of the sticker - don't cut into that inside corner. Round out that sharp corner and scrape off the ink line.

Some of the fins get star stickers.

Cut inside the dashed lines. Note the inside corners are slightly rounded off.

The stars are pretty well centered sitting right on the molding line. You'll have to visually center them from the sides.

The upper wrap sticker lines up with the top edge of the body tube.

Like all the others, wet the tube and dip the sticker into a dish of water to allow lifting and repositioning. 

The nose cone shoulder needed two wraps of masking tape to better fit the body tube.