Quest Falcon #Q1009 Build, Part 9, Name Sticker

Notice the dashed lines around the printed areas.

You'll have to cut inside those lines or they will be seen on the finished model.

I don't like the sharp inside corners. That could lead to a tear when repositioning a sticker. Chances are you will have to reposition these before burnishing them down. 

Dip and WET the stickers and body tube before setting onto the model.

TIP: Here's how to cut out the stickers to prevent tears.

The dashed lines were easily removed by lightly scraping with a knife blade.

Here's how the lower inside lines look after scraping off the dashes.

Before setting down this name sticker - 

Check the next post the see the Eagle head end of the sticker.

The name sticker actually tucks under the lip of the fin can. The red lines line up with the red lines on the fin can.