Carded Mini Goblin Build, Part 7, Launch Lug Skin

The launch lug skin gets the same glue stick coverage on the backside.

Burnish the skin onto the lug.

Note there is a slight gap where the two sides almost meet.

This is the gluing line.

I cut the BT-5 body tube a little long. It was sanded down until it was even with the body tube edge.

These nose cones have a slight shoulder lip that doesn't help with the fit in the body tube.

Round over the shoulder with 220 grit followed by 400 grit.

Fill half the nose cone with clay.

Glue the shoulder base into the nose cone.