Pages

Wednesday, July 10, 2024

Enerjet by Aerotech Initiator Build, Part 14, Finished


The aluminum motor retainer is epoxied onto the rear of the motor mount tube.

The shock cord is tied to the nose cone shoulder loop.
The nylon parachute is tied onto the shock cord, one foot away from the nose cone.








Here's the low end with the bold fin graphics.









The mid section with the somewhat tricky stickers as they are pieced together.
The final look has a good flow.




After this picture was taken, I shot the nose cone again with Ace Banner Red to lighten the tone and better match the red on the sticker below it.

The Initiator is an impressive introduction into mid-power rocketry.

1 comment: