Enerjet by Aerotech Initiator Build, Part 13, Fin Decor

After trimming the fin stickers,

Place them dry without the backing removed. Mark the corners with pencil for easier positioning.

Here's how the fin sticker was placed. 

Fourteen more to go!

With the backing peeled off, dip the decal sticky side down in water. Shake off some of the excess. 

The water on the adhesive side allows the sticker to be lifted if placement is a little off.

Any water and air can be worked out with a clean cloth, going from the center to the outside edges.

The shoulder lip got a swipe with a red Sharpie. 

The tube edge also got the Sharpie treatment.

This covers any white that could show up at the nose cone/body tube joint.