Enerjet by Aerotech Initiator Build, Part 12, Decal Stickers

Plan ahead! You'll get best results if the stickers are set in a certain order -

1.The INITIATOR name is centered and in place. 

2.The orange stripe goes down the tube, running through the open line in the Initiator name.

3. Now the upper body tube wrap can be set down, lining up the down point with the orange line already in place.

 

Start sticking the wrap with the "down point" lined up with the orange stripe - then wrap the sides.

It sometimes easier to have a end wrap sticker edge overlap the tube end. You can always shave off any overhang with a razor blade. 

You could remove the entire backing and wet the decal for re-positioning. Try to keep your fingers off the sticky adhesive. Fingerprints will show under the sticker.

Check out the dry positioning with the sticker backing still in place. 

I wanted to have equal border spacing around the color edges. This will need trimming.

The coverage of the sticker at the root edge was too wide. This will also require some trimming before being stuck on the fins.