Clear, sharp with no bubbles.
The excess was trimmed off and the canopy sanded with 220 grit wrapped around a body tube. First around a BT-50, then around a BT-55.
Initial forming over a smaller tube cuts a sharper arc. Ideally you want to sand in a straight line, up and down. There can be some wiggle. You can get a better fit starting with a smaller diameter tube.
The front and back will sand easily and fit before the sides. Keep sanding until the sides contact the tube.
Watch for the roll-around "stringers". These can be removed with light passes of 400 grit. Sand only the sides, don't scratch the clear surfaces.




What kind of vac machine do you have?
ReplyDeleteI'm planning on vac making a few Atlas fairings.
Hi Bill,
DeleteI have one like this: https://www.amazon.com/dp/B0BS23PHKX
It's small. Be ready, you will throw away the first dozen tries until you get the heating (softening) right.