Monday, November 2, 2026

Estes Strikefighter, Kit #2015, Build, Part 25, Canopy Fitting



I was lucky, I got a good canopy on the first try.
Clear, sharp with no bubbles.
The excess was trimmed off and the canopy sanded with 220 grit wrapped around a body tube. First around a BT-50, then around a BT-55.
Initial forming over a smaller tube cuts a sharper arc. Ideally you want to sand in a straight line, up and down. There can be some wiggle. You can get a better fit starting with a smaller diameter tube.



The front and back will sand easily and fit before the sides. Keep sanding until the sides contact the tube. 

Watch for the roll-around "stringers". These can be removed with light passes of 400 grit. Sand only the sides, don't scratch the clear surfaces.







Here's a near fit of the canopy. Note the sides haven't touched the tube yet. That means more sanding.

2 comments:

  1. What kind of vac machine do you have?
    I'm planning on vac making a few Atlas fairings.

    ReplyDelete
    Replies
    1. Hi Bill,
      I have one like this: https://www.amazon.com/dp/B0BS23PHKX
      It's small. Be ready, you will throw away the first dozen tries until you get the heating (softening) right.

      Delete