The kit included stickers. After you spend this much time on a build it doesn't seem right to compromise and use peel and stick trim.
The markings were drawn on Corel Draw and home printed on Bel decal paper. 3 coats of Krylon clear acrylic were sprayed on the decals.
Home print decals take longer to soak and transfer than mass produced kit decals.
I used a thin strip of aluminum Trim Monokote at the tail cone / body tube joint.
Once the strip was tucked into the root edge it was trimmed off with a razor blade. (It looks crooked but is actually straight.)
No comments:
Post a Comment