As shown before, I use Scotch tape for masking. I mark the clear tape with a wide Sharpie pen before cutting the strip.
The Sharpie ink can transfer to your fingers and onto the model. Instead of smoothing down and sealing the tape edge with a fingernail, I use a Q-tip. You can see a bit of black ink left on the Q-tip.
This tail is tucked into the open slot below tie down loop. This keeps the loose end of the cord from getting stuck between the adapter shoulder and body tube.
The rocket looks good before the decals were added.
I could have left it like this . . .
No comments:
Post a Comment