My first nose cone didn't quite match up to the body shroud.
Everything else fit fine, my construction or home print could have been off.
I drew up a longer nose cone.
There are three nose cone prints on the second sheet. These are difficult to form so you might need a second or third try.
The nose block was pulled from the first nose cone.
Patreon supporters can request the additional PDFs. Email me at oddlrockets@bellsouth.net and ask for the Space Raider PDF.
After the nose cone was formed, some extra glue was rolled over the glue tab with a Q-tip.
I marked the four sides at the glue contact points.
Here's the longer nose cone. Not perfect but much better than the first try.
Hi Chris!:
ReplyDeleteHow long did you end up cutting your nose cone block?
Sincerely,
J.W.
Hi J.W.,
DeleteIt ended up at 3/4" long. That leaves 1/2" exposed to slide into the body tube.
Thanks!
DeleteJ.W.