Semroc Wac Corporal Build, Part 11, Fitting The Fins

There was still some uneven areas around the tail cone/body tube joint.

Wedge shaped pieces of masking tape were cut to keep another shot of filler/primer of the root edge gluing areas.

The filler/primer was sanded down.

Each fin was individually fit to the tail cone and body tube.

Look close and you can see a small gap at the rear and just below the top of the tail cone.

Here's the same fin after fitting. The gaps are gone. 

For a reference I marked the fin at the shroud/body tube joint with pencil.