Estes Advanced Target Drone, Kit #1913, Build, Part 12, Template Testing & Adjustments

You should check the template before tracing and cutting out the decal.

The paper template is place over the decal position, in this case on the wing. Make any adjustments to the template, your intake fit over the wing might be a little different. 

This is the paper template fit on the rudder fin.

There is a little overlap on the rounded leading edge.

The leading edge of the template will be trimmed back so the final decal won't be peeling back later.

The pencil tracings are made around the templates onto the white sprayed decal sheet.

This is the rudder decal. Trace once, then flip over and trace again for two "mirrored" decals.